Length (Coil cord):
Overall: 6 ft. and 12 ft. Straight section: 8-10 inches each end
Electrical Properties:
Current - Minimum current carrying capacity 25Ma. Resistance: End-to-end resistance
less than 50 ohms, excluding resistor. Standard resistor - 1 megohm, ¼ watt
Snap/Sizes:
Post snap (4mm) - 7mm or 10mm. All metal parts are non-rusting - tested to U.S.
MIL STD 202 Method 101
Inner Core:
4 Strands of T3161 tinsel with
polyester core
UL Listed
File E157590
Outer Insulator:
Insulative to more than 300 megohms measured at 1KV DC
Strain Relief:
Specially designed, extending between 15-20mm at both ends molded from nylon.
Tested to more than 200,000 flexes without any detrimental effect.
Marking:
Standard or custom logo, date and lot-coded.
Meets or exceeds:
DOD-HDBK-263
DOD-STD-1686
EOS/ESD STD No. 1-1987
EN10015/1
This document is prepared for our customers as a service, and is to the best of our knowledge true and accurate. However, it is understood and agreed by the users of this document that we will accept no liability for the conclusions reached. In addition, the products discussed are sold without warranty, expressed or implied, and this document is not to be construed as making any such warranties. Users of this document may therefore wish to perform additional testing before determining that products mentioned are suitable.